Allen-Bradley 2711PC-T10C4D1 PanelView Plus 6 Compact Terminal

Allen-Bradley 2711PC-T10C4D1 PanelView Plus 6 Compact Terminal

Configured for touchscreen-based operator interface and Ethernet/RS-232 data communication in the PanelView Plus 6 Compact platform, the Allen-Bradley 2711PC-T10C4D1 (2711PC-T10C4D1 PanelView Plus 6 Compact Terminal) provides direct operator input through a 10.4 in. color TFT display and analog resistive touchscreen.

Hardware Specifications

Ethernet, Serial and I/O Interface Characteristics

The terminal provides an embedded Ethernet interface, an RS-232 communication interface, and two USB host ports. Ethernet and RS-232 provide the primary external communication paths identified in the supplied specifications, while the USB interfaces provide host connectivity. The supplied data does not define a specific Ethernet protocol, network determinism class, port isolation rating, or communication latency; these parameters should therefore be verified against the applicable PanelView Plus 6 Compact technical documentation before system design.

The 18-32 VDC input range permits operation from a nominal 24 VDC control supply. The stated 70 W power figure should be considered when sizing the field power supply and associated protection.

Frequently Asked Questions (FAQ)

Q: What display and touchscreen hardware is installed in the 2711PC-T10C4D1?

A: The terminal has a 10.4 in. color active-matrix TFT display with 640 x 480 resolution and 18-bit color graphics. Operator input is provided by an analog resistive touchscreen.

Q: Which physical communication interfaces are integrated?

A: The supplied specifications identify Ethernet, RS-232, and two USB host ports. No additional communication interfaces are specified.

Q: What supply voltage is required?

A: The specified input voltage range is 18-32 VDC, with 24 VDC identified as the nominal input power voltage. The supplied data lists 70 W power consumption.

Field Installation Guidelines

• Install the terminal within the specified enclosure requirements. The supplied enclosure classification is NEMA/UL Type 12, 13, 4X for indoor use and IEC IP54/IP65.
• Provide a regulated 24 VDC control supply within the specified 18-32 VDC input range.
• Size the DC power supply and branch protection for the stated 70 W power requirement and the complete connected load.
• Route Ethernet and RS-232 communication wiring separately from high-voltage and high-current power conductors where practical to reduce conducted and radiated interference.
• Maintain appropriate cable shielding and grounding practices for the installed communication system. Shield termination should follow the applicable Allen-Bradley installation instructions and plant grounding scheme.
• Verify connector seating and cable strain relief before energizing the terminal.
• Do not assume hot-swap capability for the terminal or connected communication interfaces unless explicitly permitted by the applicable hardware documentation.
• The CCFL backlight is field replaceable according to the supplied specifications; replacement work should be performed with the terminal de-energized.
• Verify the installed firmware and application compatibility before commissioning, particularly because the supplied lifecycle status identifies the unit as end of life.