ProSoft RLX2-IHNF Industrial Wireless Radio

ProSoft RLX2-IHNF Industrial Wireless Radio

Configured for high-speed wireless Ethernet communication in industrial networks, the ProSoft RLX2-IHNF (RLX2 Industrial Wireless Radio) provides wireless bridging, repeater, client, and access point functions. It supports IEEE 802.11a/b/g/n operation, dual-band radio communication, 2x2 MIMO, and data rates up to 300 Mbps.

Hardware Specifications

ProSoft RadioLinx Wireless Network Characteristics

The RLX2-IHNF uses MIMO radio architecture to support packet transmission rates up to 300 Mbps. Three RP-SMA antenna interfaces are provided for external antenna connections.

The radio operates across 2.4 GHz and 5 GHz bands, subject to configured wireless channels and applicable regional radio regulations. The Ethernet interface supports 10/100/1000 Base-T communication through an RJ45 connector.

Wireless operating modes include Access Point, Repeater, Client, and Wireless Bridge configurations. These modes allow the unit to participate in point-to-point, point-to-multipoint, and network extension architectures.

The supplied data specifies less than 10 ms handover time for fast roaming. This characteristic supports moving wireless clients where uninterrupted network communication is required.

Network functions include VLAN, NAT, QoS, and IGMP Snooping. Security functions include WPA and WPA2 mechanisms with 802.1X and AES options.

The unit provides an RS-232 DB9 interface for serial encapsulation or configuration functions. The aluminum enclosure supports DIN rail or panel installation.

Frequently Asked Questions

Q: Can the RLX2-IHNF operate from both DC power and PoE?
A: Yes. The supplied specifications identify 10 to 24 VDC input and IEEE 802.3af-compliant Power over Ethernet.

Q: How many external antenna connections are provided?
A: The supplied hardware specification identifies three RP-SMA female antenna connectors.

Q: What wireless standards and maximum data rate are supported?
A: The radio supports IEEE 802.11a/b/g/n operation with 2x2 MIMO and a specified maximum data rate of 300 Mbps.

Field Installation Guidelines

Install the RLX2-IHNF on a stable DIN rail or suitable panel surface with adequate enclosure clearance.

Use shielded Ethernet cabling where required by the surrounding electromagnetic environment. Separate Ethernet, antenna, and DC power wiring from high-current motor, drive, and switching circuits.

Connect external antennas using compatible RP-SMA assemblies and maintain the antenna cable routing recommended by the system design. Avoid sharp cable bends and unnecessary cable length.

Terminate the protective earth connection according to the applicable industrial enclosure and grounding scheme. Avoid creating unintended ground loops between separately grounded network equipment.

Verify the DC supply polarity and voltage before energizing the unit. When PoE is used, confirm that the supplying equipment complies with IEEE 802.3af requirements.

For wireless deployment, verify channel assignments, antenna orientation, radio coverage, and interference levels before commissioning. Configure VLAN, QoS, NAT, and multicast functions only when required by the network architecture.

For installations involving hazardous-location requirements, verify the exact certification marking of the supplied RLX2-IHNF variant before installation. Certification applicability depends on the specific hardware and installation conditions.