Epro A6110 Shaft Relative Vibration Monitor

Overview:

• High-performance, dual-channel shaft relative vibration monitor
• Designed for critical machinery applications
• Provides accurate and reliable vibration monitoring

Technical Specifications:

• Transducer Inputs:

  • Number of Inputs: Two, independent or combined monitoring modes
  • Type of Inputs: Eddy current, differential
  • Isolation: Galvanically separated from power supply
  • Input Resistance: >100 kΩ
  • Input Voltage Range: 0 to -22 VDC
  • Input Frequency Range: Lower cutoff: 1 or 5 Hz; Upper cutoff: 50 - 2000 Hz adjustable

• Measuring Range:

  • Range: Continuously adjustable with configuration software
  • Smallest Range: 0 - 400 mV
  • Largest Range: 0 - 8000 mV

• Sensor Power Supply:

  • Nominal Voltage: -26.7 V
  • Available Current: Nominal 20 mA, maximum 35 mA
  • Separate buffered sensor supply
  • Galvanically separated from all system voltages
  • Open and short circuit proof

• Outputs:

  • Front Panel Outputs: Green and red LEDs for channel status
  • Front Panel Buffered Outputs: ±10 V, >100 kΩ load, frequency range 0.1 - 5 kHz (-3 dB)
  • Rear Outputs:
    • Current Mode Outputs: 0/4-20 mA output proportional to main value
    • Voltage Mode Outputs: 0 - 10 VDC output proportional to main value
    • Rear Buffered Outputs: Raw buffered output signal, AC and DC

• Analysis:

  • Measurement Modes: Hot configurable, zero to peak, peak to peak, independent dual-channel or combined modes, Smax (combined) (DIN 45670A), Smax peak to peak (combined) (DIN 45670B, VDI 2059), Smax 0 to peak (combined) (VDI 2059), True S peak to peak Y. X (independent) (API 670)
  • Analysis Parameters: ½x, 1 - 10x and phase angle of same, available via ModBus TCP/IP output